1590 buckeye drive - milpitas, ca 95035 - tel: 408-432-9898 - fax: 408-432-1551 - components@remec.com - www.remec.com specifications subject to change without notice. specifications subject to change without notice. 3-13 remec double balanced mixer communications band rf 3.5-15.0 ghz lo 3.5-15.0 ghz if dc-4000 mhz mc5 x sm x -7 mc5 x sm x -14 lo(ghz) 3.7-14.5 3.7-14.5 3.5-15.0 3.5-15.0 3.5-15.0 3.5-15.0 3.5-15.0 3.5-15.0 rf(ghz) 3.7-14.5 3.7-14.5 3.5-15.0 3.5-15.0 3.5-15.0 3.5-15.0 3.5-15.0 if(mhz) dc-500 dc-2000 dc-4000 dc-2000 dc-4000 dc-4000 dc-4000 dc-4000 min 26 db 21 db typical 5.0 db 5.5 db 7.5 db 35 db 30 db 23 db +20 dbm +14 dbm +1 dbm +4 dbm +8 dbm +12 dbm +11 dbm +14 dbm +18 dbm +22 dbm +7 dbm +10 dbm +13 dbm +18 dbm max 7.0 db 8.5 db 9.5 db mc53 mc54 mc56 mc57 mc53 mc54 mc56 mc57 mc53 mc54 mc56 mc57 conditions specifications electrical specifications (1) : lo power 3 = +7 dbm 4 = +10 dbm 6 = +13 dbm 7 = +18 dbm parameter ssb conversion loss: (2) (3) isolation lo to rf: lo to if: rf to if: if to rf: input 1-db compression point: input third order intercept point: lo power: (4) mc5 x sm d-7 notes: 1. specifications are guaranteed when tested as a downconverter in a 50 ohm system at +25c with the nominal lo power. specifications indicated as typical are not guaranteed. 2. noise figure is typically within 0.5 db of conversion loss. 3. conversion loss typically degrades less than 0.5 db at +100c and improves less than 0.5 db at -55c. 4. usable lo drives are up to 2 db below and 3 db above nominal. 5. see application note m112, for aid in selecting the outline and for mounting and installation information. typical performance at 25 c mc5 x sm h-7 d = no cover h = with cover note: see pc board footprint - fp1 on page 3-61 all dimensions are in inches and [mm]. outline: smmc4a: as shown smmc4b: rf & lo reversed outline: smmt4a: as shown smmt4b: rf & lo reversed mc5xsmx-7: as shown mc5xsmx-14: rf & lo reversed
|